The Berkeley Nucleonic's Model 8010 is an inexpensive general purpose pulse generator with a broad operating range. Its two outputs provide for the maximum in output waveform flexibility. For example, one may have TTL and ECL levels simultaneously. The internal clock rates, 1 Hz to 50 MHz, together with external trigger, single cycle, and synchronous and asynchronous gating gives the user a very broad range of pulse train control. The Model 8010 is packaged in an AEC NIM module, a convenient standard in the non-nuclear as well as nuclear field. The compact size of the module (the front panel is only 2.7" x 8.7") permits independent use or easy interconnection of multiple pulsers in a system.
Overview
- Frequency Source or Oscillator
- Triggerable Pulse Source
- Gate or Width Generator
- Double Pulser
- Single Cycle Pulser
- Gateable Oscillator
- Delay Generator
- Four-Output Pulser
Specifications
| Frequency | A: 1 Hz to 50 MHz in 8 ranges, continuously adjustable.
B: External trigger, O Hz to 50 MHz. C: Single cycle by front panel pushbutton. |
| Delay | Less than 25 ns to 1 s in 9 ranges, continuously adjustable. |
| Width | Less than 20 ns to 1 s in 9 ranges, continuously adjustable. |
| Positive Output | A: Normal or complement; switch selectable.
B: Amplitude: 500 mV to 5 V continuously adjustable into 50 Ohms (TTL logic). C: Rise and fall time less than 5 ns. |
| Negative Output | A: Amplitude: fixed -0.8 V pulse (NIM logic) into 50 Ohms, or -1.5 V with base line offset of -0.5 V into 50 Ohms (ECL logic); switch selectable.
B: Rise and fall times less than 3.5 ns. |
| Duty Factor | Greater than 50% each output, in complementary pulse mode duty factors larger than 90% may be attained. |
| Trigger Out | Positive +1.1 V square wave into 50 Ohms. |
| External Trigger | Requires positive l V, with rate of rise greater than 3 V/,us. |
| Waveform Distortion | Less than 5% at full amplitude. |
| External Gate | Synchronous or asynchronous; switch selectable. Requires a positive 1.5 V signal. |
| Single/Double Pulse | Switch selectable, minimum double pulse spacing of 20 ns. Pulse separation set by delay controls. |
| Jitter | Repetition rate, delay or witdh, 0.1% +50 ps |
| Mechanical | Double witdh AEC module, 2.7" wide x 8.7" high in accordance with TID-20893 (Rev. 3). |
| Weight | 3 1/2 lbs., net; 7 lbs., shipping. |
| Power Requirements | A: +12 V @ 380 mA, -12 V 100 mA, or:
B: +12 V @ 80 mA, -12 V @ 100 mA, +6 V @ 300 mA, selectable internally. Easily changed by removing side and throwing slide switch into either position. |
Downloadable resources such as datasheets, firmware, software, drivers and products manuals. Alternatively, you can browse resources directly by visiting our downloads page.
• Product Datasheets
• Product Firmware
• Product Software and Drivers
• Product Manuals